Raised-panel steel
Carriage house
Modern flush
Full-view glass
LiftMaster openers
Chamberlain openersFull 25-point door and opener safety check with every visit - springs, cables, rollers, tracks, and your LiftMaster or Chamberlain opener included
You get a price before we start. It does not change when the pro arrives.
Get your free estimateStyles & brands we work with
- Raised-panel steel
- Carriage house
- Modern flush
- Full-view glass
- LiftMaster openers
- Chamberlain openers
See the difference
Before
After
Before
After
Before
AfterHow Much Does Spring Replacement Cost in Framingham?
Spring replacement in Framingham typically costs $180 – $340 per spring. Most homes have two springs that wear out together, so a matched pair usually runs about twice that, or roughly $360 – $680. The written estimate sets the final price once we see the door and the springs on it.
That range covers the spring itself and the labor to swap it safely. What it doesn’t cover is a bent track, a frayed cable, or a damaged panel that shows up during the job – those are quoted separately and only after you’ve agreed to them.
Key Takeaways
- One spring: $180 – $340. A matched pair is usually about double that.
- Springs are under heavy tension and can cause serious injury – this isn’t a job to attempt yourself.
- Cold Framingham winters work torsion springs hard; a door that groans or lifts unevenly is telling you something.
- Estimates are free, and we quote before any work starts.
- Call (877) 665-1930 for an exact price on your door.
Spring Replacement Cost Breakdown (2026)
Here’s how the numbers break down for a typical residential spring job in Framingham. These are estimated ranges, not a menu – every door is a little different, and the final figure comes from the written estimate.
| Item | Typical Estimated Range |
|---|---|
| One torsion spring (replacement) | $180 – $340 |
| Matched pair of springs | About $360 – $680 (roughly twice the single-spring range) |
| Extension spring (per spring) | $180 – $340 |
| Cable repair, if a cable is frayed or off its drum | $130 – $250 |
| Roller replacement, when rollers are worn | $110 – $220 |
| Track realignment, if the door is binding | $120 – $240 |
| Panel replacement, for impact or rust damage | $250 – $500 |
| Opener repair, if the opener was strained by a broken spring | $120 – $320 |
What pushes the price up: the size and weight of the door, whether it carries one spring or two, whether the springs are torsion (the horizontal shaft above the door) or extension (the springs that run along the tracks), and whether anything else let go when the spring did. A door that’s been run on a broken spring for a week often takes a cable or a set of rollers with it. What keeps it down: a standard-weight door, a clean single-spring swap, and springs that fail at the winding point rather than tearing up the shaft.
If your door is stuck and you need it working today, our Framingham Garage Door Repair Pros handle the full range of repairs, and spring replacement is one of the jobs we do most.
What Affects Spring Replacement Pricing in Framingham
Framingham has a mix of housing that shapes the work. 1950s capes and ranches around Saxonville and Coburnville often carry lighter single-car doors on one torsion spring. Larger doors in the neighborhoods off Pleasant Street and along the Southside tend to be double-car and heavier, which means a pair of springs sized for that weight. And the town’s long run of cold winters – stretches below freezing, occasional ice storms off the Framingham line – cycles those springs hard every year. Metal that’s wound and unwound thousands of times in the cold fatigues faster than the same spring in a milder climate.
- Door weight and width. A single-car door needs a lighter spring than a double-car door. Heavier doors take heavier springs, and that shows up in the price.
- One spring or two. Two springs share the load and are usually replaced as a pair. Replacing one and leaving the other is a false economy – the old one is on the same clock.
- Torsion vs. extension. Most newer Framingham doors use torsion springs on a center shaft. Older doors with extension springs along the tracks are priced per spring, and the hardware may need refreshing.
- Condition of cables, drums, and rollers. A snapped spring often takes a cable with it. If the drums are worn or the rollers are flat-spotted, you’re paying for those too.
- Winter timing. Springs fail most often in the cold, and that’s when a lot of Framingham homeowners call. Expect the job to be booked fast in January and February.
- Access and door height. A standard seven-foot door is straightforward. An eight-foot door or a tight ceiling in a low garage takes longer and a different spring.
One thing worth saying plainly: springs are the most dangerous part of a garage door. They’re under hundreds of pounds of tension, and a spring that lets go while someone is winding it can break an arm. We recommend leaving this to a trained technician, and we mean that whether you call us or someone else. Our technicians have up to 12 years of experience, and they work on springs every week, not once a season. Garage doors are all we do.
How to Save on Spring Replacement
There’s no coupon for a spring, but there are real ways to keep the bill at the low end of the range.
- Replace the pair, not the single. It costs more today, but you avoid paying labor twice when the second spring fails a few months later. On a two-spring door that’s the single biggest saving over time.
- Get the estimate before the work. A free estimate costs you nothing and tells you exactly what the job runs. Call (877) 665-1930 and we’ll price it out.
- Deal with the small stuff while the door is open. If the rollers are shot or a cable is frayed, fixing it during the spring job is cheaper than a separate visit later. Most of that cost is labor, and the labor is already there.
- Don’t run the door on a broken spring. Forcing an opener to lift a door with a dead spring strains the motor, the gear, and the rail. That turns a spring job into a spring-plus-opener job.
- Ask what brand hardware is on the door. We work on LiftMaster, Chamberlain, Genie, Clopay, Amarr, Wayne Dalton, Craftsman, and Raynor systems, so we know the right parts for what’s already on your home instead of guessing.
- Don’t put it off through the winter. A tired spring in November is a snapped spring in February, usually on the coldest morning of the year.
If you’re weighing the cost of a repair against a new door, our garage door repair page covers the full range of repair pricing so you can compare. A single failed spring almost never justifies a new door. A door with a cracked panel, worn tracks, and a strained opener might.
FAQs – Spring Replacement Cost
How much does it cost to replace a garage door spring in Framingham?
One spring typically costs $180 – $340 in Framingham, and a matched pair runs about double that, roughly $360 – $680. That’s the estimated range for a standard residential door. Call (877) 665-1930 for an exact quote – estimates are free.
Is it cheaper to repair or replace a garage door with a broken spring?
Repair is almost always cheaper. A spring replacement at $180 – $340 per spring is far less than a new door at $700 – $2200, and it’s the right call unless the door itself is damaged. If a panel is cracked, the tracks are bent, and the opener is straining, a new door may make more sense. Call (877) 665-1930 and we’ll tell you honestly which side of that line your door is on.
Can you replace my springs the same day?
Often yes. Spring replacement is a same-day job when the right spring is on hand, and we run a dedicated emergency line for doors that are stuck open or won’t close. A door hanging open on a Framingham winter night is a security problem, so we treat it that way. Call (877) 665-1930 and we’ll get you on the schedule.
Why do springs break more often in Framingham winters?
Cold shrinks and stiffens the steel, and a spring that’s near the end of its life is far more likely to snap on the first hard freeze than in July. Framingham’s winters are long enough that most springs cycle through thousands of cold cycles, and that’s the wear that does them in. If your door sounds different in December than it did in October, that’s the warning.
Do I need a permit to replace a garage door spring in Framingham?
Spring replacement is a repair, not a structural change, and most homeowners don’t need a permit for it. If you’re replacing the whole door or changing the opening, permit rules can apply, so check with the Framingham building department before the work. For spring work, call (877) 665-1930 and we’ll quote the job – estimates are free.
We offer free estimates on every spring job, upfront pricing before any work begins, and a satisfaction guarantee. If your door is stuck, don’t force it. Call (877) 665-1930 and we’ll get a technician out to look at it.
Pricing reflects the Framingham market as of 2026. Framingham Garage Door Repair Pros offers free estimates – call (877) 665-1930.
What Our Customers Say
"Opener works, remotes are programmed, no complaints on the work. Took three days to get on the schedule though, so if you've got a car trapped inside, say so when you call."
- Ramon Flores"Door installed in about four hours, old one hauled away, and he stayed to program both cars and the wall panel before he left."
- Ryan Whitaker"The old chain drive sounded like a freight train through the bedroom above the garage. Went with the belt drive they recommended and now I genuinely cannot hear it open from upstairs."
- Christine Nguyen